IMPORTANT KEYS

Press Enter after each selection or command. Press Exit to go back to previous screens. Press Enter to accept a default setting.

CLONING

Transfer programming from one programmed QUIKPAGER (Sending) to another QUIKPAGER (Receiving) over the RS-232 port.

74. Prepare the receiving QUIKPAGER following steps 1 to 4.
75. Interconnect QUIKPAGERs using a 9 pin, RS-232 cable and a Null Modem Adapter. See Figure 1



76. Type !RECEIVE in receiving QUIKPAGER and press ENTER. DO NOT PRESS Y YET.
77. Type !SEND in sending QUIKPAGER and press Enter.
78. Press Y in sending QUIKPAGER AND IMMEDIATELY AFTER, press Y in receiving QUIKPAGER. If there is no ++++ on screen within 20 seconds, press Exit and repeat steps 76 to 78.

TRANSFERRING PROGRAMMING OVER THE PHONE LINE

Transfer programming from one programmed QUIKPAGER (Calling) to another QUIKPAGER (Answering) over the telephone line.

79. If Answering QUIKPAGER is already programmed, go to step 80, otherwise prepare the answering QUIKPAGER following steps 1 to 4.
80. Type !ANSWER in Answering QUIKPAGER and press ENTER.
81. Press Y. "Waiting for call" will be displayed.
82. Type !CALL in Calling QUIKPAGER and press Enter.
83. Type the telephone number of Answering QUIKPAGER. Press Enter.
84. If within 45 seconds there is no ++++ on screen, press Exit and repeat steps 82 to 83.